Bayou Classic 700-709 Owner's Manual Page 15

  • Download
  • Add to my manuals
  • Print
  • Page
    / 28
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 14
13
REGULATOR HOSE ASSEMBLY
Y
our fryer is equipped with a Type-1 connection device
with the following features:
1. The system will not allow gas flow from the cylinder
until a positive connection to the cylinder valve has been made.
NOTE: The cylinder valve must be turned off (clockwise)
before any connection is made or removed.
2. A flow limiting device, when activated, restricts the
flow of gas to 10 cubic feet per hour.
NOTE: the flow limiting device can be activated when
attempting to light fryer. If this occurs, refer to Trouble Shooting on pages 23 - 24 for proper remedy.
WARNING
Never use your fryer without leak testing all gas connections, regulator hose assembly and weld
seams on propane tank. See the section on "Gas Leak T
esting" in this manual for proper procedures.
WARNING
The pressure regulator and hose assembly supplied with your gas fryer is designed to work with an
LP gas supply cylinder
.
DO NOT attempt to connect it to any other fuel supply source such as a natural gas line.
DO NOT use any other pressure regulator/hose assembly than the one supplied with your fryer.
DO NOT attempt to adjust or repair the regulator. A replacement regulator can be supplied by
contacting Barbour International, Inc. at 1-800-864-6194. The regulator is designed to operate at
a maximum output pressure of 10 psi (pounds per square inch).
CONNECTING REGULATOR HOSE ASSEMBLY TO FRYER
The Regulator Hose Assembly is a pre-assembled unit. Do not take
apart. Simply connect the regulator
hose assembly to the LP gas cylinder and to the fryer. An adjustable wrench is needed when attaching
the hose to the burner on the fryer.
Visually inspect the regulator hose assembly prior to each use. If there is evidence of abrasion, wear,
cuts or leaks, the hose must be replaced prior to the appliance being put into operation.
Call 1-800-864-6194 for replacement Model #M5HPR-1. M-F 8am - 5pm CST.
Attach hose connector to the burner on the fryer as shown below.
For connection to
LP Gas Cylinder
TYPE-1
Connector
Coupling Nut
Brass
Connector
For connection
to Fr
yer
Turn Clockwise
W
rench Tighten
Light BURNER
Connect to Tank
(Clockwise)
Disconnect from Tank
(Counter
-Clockwise)
Decrease
Gas Flow
Increase
Gas Flow
Caution: The Regulator Valve
Controls the "V
olume" of Gas ONLY.
Use the Valve on the Propane Tank to turn Gas Supply "ON" or "OFF".
PRESET REGULATOR
WITH SIDE V
ALVE
Regulator Valve
JET BURNER
Page view 14
1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 27 28

Comments to this Manuals

No comments