Bayou Classic 700-709 Owner's Manual Page 25

  • Download
  • Add to my manuals
  • Print
  • Page
    / 28
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 24
23
Problems with lighting the fryer:
1.
LP Hose Regulator assemblies and propane tanks are equipped with a safety device to reduce 90% of
gas flow should the hose be cut or severed. Sometimes this safety device may be activated when lighting
the fryer. To prevent this, ALWAYS make sure the regulator valve is in the closed position (see illustration
below) before opening the valve on the LP Cylinder. Then SLOWLY open regulator valve to light.
CLOCKWISE
to closed position
PRESET REGULATOR
WITH VALVE
NOTE: Prior to lighting, turn regulator valve to CLOSED position
before opening the valve on LP Cylinder
. Then S-L-O-W-L-Y open
regulator valve to light.
Prior to lighting, turn regulator valve to CLOSED position.
TROUBLE SHOOTING TIPS
2. The excess flow safety device can also be activated by opening the cylinder valve too fast.
So remember;
Open cylinder valve S-L-O-W-L-Y and open regulator valve S-L-O-W-L-Y.
S-L-O-W-L-Y Turn
LP Cylinder Valve One Full Turn
counter-clockwise
O
N
-
C
O
U
N
T
E
R
-
C
L
O
C
K
W
I
S
E
O
N
-
C
O
U
N
T
E
R
-
C
L
O
C
K
W
I
S
E
S-L-O-W-L-Y
Turn Regulator Valve ON
counter-clockwise
STORAGE OF FRYER
1.
Store fr
yer in a dry place. Do not store outside exposed to weather. Storage of a gas appliance indoors
is permissible only if the cylinder is disconnected. If storing fryer indoors, detach and leave LP cylinder
outdoors. LP cylinders must be stored outdoors out of the reach of children and must NOT be stored
in a building, garage or any other enclosed area.
2. For long term storage, cover the burner in-take and exhaust vent with a plastic bag to prevent wasps,
spiders and dirt dobbers from building nests inside the heat tubes.
3.
The heat tube can be cleaned by disconnecting both exhaust vent and burner in-take and using a
garden hose, spraying water through the system.
4. Inspect entire appliance including regulator hose assembly before each use. Replace any damaged
or worn parts. Use only parts specified by Barbour International, Inc.
WARNING
A clogged heat tube can result in flames exiting the exhaust or a back-flash at the burner intake.
Inspect heat tube prior to each use.
Page view 24
1 2 ... 20 21 22 23 24 25 26 27 28

Comments to this Manuals

No comments